When installing internal wall insulation, the reveals around windows and doors are often left untreated due to lack of space to fit conventional insulation.
Failure to address these areas will lead to condensation, damp and mould related problems.
By combining Aerogel insulation, the world’s most efficient and thinnest Insulation Material, with an extremely robust 6mm Magnesium board, Enviroform solutions have developed a 16mm thick reveal board.
E-LINE REVEAL, with a thermal resistance of 0.8m2k/w, reduces the heat loss at these critical junctions to eliminate the risk of condensation and mould related problems.
E-LINE REVEAL is supplied in two different formats
Type I- 16mm x 1200mm x 2400mm
Type I does NOT contain a vapour control layer and is used with a Vapour open (VO) System
Type II- 16mm x 1200mm x 2400mm
Type II has an integrated vapour control layer and used when installing a Vapour Tight (VT) System
Reduces heat losses through reveals.
Reduces risk of condensation
Reduces risk of mould growth
Does not cover window frame
Adds to the overall performance of your insulation upgrade
The Junction between the window frame and the wall, (as per the drawing) must be sealed using MagnaSeal.
This provides an Air and Vapour tight seal which is critical to the overall performance of the Install
This Thermal Laminate is then fixed to the wall leaving the insulation flush with the edge of the existing reveal, and the board finishing 16mm into the window opening
Measure Internal Dimensions of Window and Floor
Mark the length and width of the reveal to be cut
Cut using circular saw or handsaw